My Life Saver Inhaler Case – IN THE HOOP
“This is Not a SHIPPED PRODUCT “
hoop size- 130 x 180
The following file formats are included:
You do need an Embroidery Machine to complete this project!!:
Step 1 – Hoop Stabilizer and stitching out placement slip
Step 2 – Lay vinyl in the hoop and cover all stitch lines
Step 3- Stitch out Center design
Step 4 – Take hoop out and tape other vinyl on back of hoop and cover all stitch lines
Step 5 – Placement holes is the last stitch step
Step 6 – Remove and trim and add Kamsnap to Inhaler
The finished size of the case is 6.25 inches tall and 5 inches wide.
Inside diameter is about 4.25″. To see if your inhaler will fit, measure the distance around the entire inhaler, it needs to be smaller than 4.”.
Fits most inhalers, but as some are unusual sizes, will not fit all. Shown with a Albuterol inhaler.
Requires to make Inhaler:
Vinyl for haler
_ Kamsnap Pliers
You may use this file to create items for resale, however, you may NOT RESALE, TRADE, ALTER, or SHARE this DIGITAL FILE in any way.
Due to the nature of this DIGITAL FILE, no refunds will be issued. This listing is NOT for a physical item.
*****This is a digital file that must be used with an embroidery machine*****
This listing includes designs pictured, and each design has multiple hoop sizes!
(This version has 1 files formatted to fit the hoop sizes 180 x 130)
All designs drawn by Robin Wilds. For custom designs see www.thestitchingwitch.com
© Robin Wilds 2019